List of AUU type used in 5G Optus Upgrade
New 5G site design project by Revit in ACT Australia
Telecom Equipment family design in Revit
Site design with Revit
presentation rendering with Twinmotion
Prior to Revision 6, the Antennas EME Exclusion Zones drawing (‘R1’), when provided, showed occupational and general public EME exclusion zones ‘plume’ diagrams, based on information provided by Optus, for single isolated antennas with...
The Supplier will notify Optus at least 24 hours in advance of inspections required or requested to be made by Optus or their representative. Where inspections are required by Council or other statutory or...
Term / Abbreviation
Computer Aided Drafting
Process within the OPTUS Drawing Management System where OPTUS approved drawing file is uploaded into the system.
Process within the OPTUS Drawing Management System to download a...
As Built Drawings instruction
The Supplier’s QMP must set-out a process for the production of the Site As-Built drawings. As-built drawings are to be produced for all site works that involve any external works or...
Draft Site Layout (DSL) Drawings
Prime & Backup Candidates
Draft Site Layout drawings for the prime candidate are intended for presentation to site providers and relevant authorities, therefore the drawing presentation is important. It should correctly...
Optus & Vodafone 5G SOW
The initial release of this document is intended to provide all information necessary for site upgrades
to achieve "Phase 1" of the 5G eJV project, at which point a SAED vendor...
Telecom EME Signage in Australia
Definitions & Abbreviations
IBS Low Power Antenna (In-Building System refer Section 5.1 of RFSCP)
Cat 1 IBC = General Public Limit not exceeding 100mm from any one antenna
Cat 2 IBC = General...